Structural Timber Gallows Brackets ~ Straight brace dual pitch gallows bracket SG32/T. S.W.L. 296 kgs.

Dual pitch straight brace bracket, mortise and tenon jointed.

The prices quoted below are Ex works and exclude V.A.T.

Delivery cost and V.A.T. will be added when proceeding to the on line checkout.

The gallows brackets are constructed as follows. The timber is European redwood, kiln dried. All joints are stop mortise and tenon 19mm & 22mm) wide. Glued with urea formaldehyde powder resin mixed with water and brush applied to tenons.

Finish
Planed all round timber. All curved surfaces bandsawn, and spindle moulder planned to profile. Bevels are 10mm and 12mm across the flats. All seen surfaces are twice sanded (80s grit and 100s grit) sandpapers.


Decorative feature's
A cross grain trench 17mm wide 12mm deep is cut 100mm up from the base of the upright to three faces.
Return 45 degree cross grain bevels are cut to the ends of the head and upright 25mm x 25mm.
Stop bevels are applied to leading edges of the head and upright and to fore edges of the brace.

Assembly
Glued components hand assembled, pneumatically clamped. All joints secured with headless aluminium pins.

Safe Working Load
The safe working load is stated for each product below, this has been calculated at a factor of safety of six.

Structural Suitability
Calculations to find the load including snow,wind load etc should be obtained to prove the suitability of the product for your application.

Treatment
Dip treated with Gasurit glassohyd natura base coat fungicide stain.

Packaging
Products banded, corner protected and cling film wrapped.

Delivery
Usually dispatched next day.